For Canadian installation in both flush and down-
rod mode the safety cable must be installed into
the house structure beams using the 3” lag screws
provided. Make sure that when the safety cable is
fully extended the leadwires are longer than the
cable and no stress is placed on the leadwires.
Hang assembled fan from the mounting bracket
installed to ceiling in previous step. Make sure the
fan is hanging straight. Rotate fan until the tab on
the Mounting bracket engages the slot on the
Downrod Ball. This must be done to prevent the fan
body from rotating when the blades are in motion.
8
9
Safety Cable
Lag Screw
Lag Screw
Safety Cable
Washer
Lock Washer
Install blade and blade bracket
to motor with the screws
on the
screws
Loosen 2 screws and remove 1 screw
from motor plate. Save removed
screws for use later.
17
18
Place blade brackets onto blades
aligning holes in blade bracket
with holes in blade. Install 3
screws and fiber washers to back
side of blade as shown. Tighten
screws securely. Repeat this
process 2 more times until all
blades are assembled.
16
Remove the shipping stabilizers
attached to the motor.
7
Install the canopy with the 2 hex
nut screws by using the hex-nut
driver provided(As shown).
Tighten hex-nut screws securely.
15
Set dip switches on the Remote Transmitter and Remote
Receiver to the same settings. This must be done so the
units will communcate properly. If you have other fans you
can set to control from one transmitter by setting both
receivers the same as the transmitter. If you have more
than one fan with remote. You can set the dip switches to
different positiosns to have seperate control.
Remote Transmitter Dip swtiches
Remote Receiver Dip switches
10
white
black
Make wiring connections as indicated above.
White from fan to white from remote marked
N. Blue from fan to blue from remote marked
light. Black from fan to Black from remote
marked L. White from house to white from
remote marked AC N . Black from house to
Black from remote marked AC L. Connect all
green ground wires to Ground wire from
House.
blue
Green
white
black
House
Fan
13
fuses
Make wire connections to power source using wire
nuts provided. Make sure that no filiments are out-
side of the wirenut. After making the wire connec-
tions, the wires should be spread apart with the
grounded conductor and the equipment-grounding
conductor on one side of the outlet box and unground-
ed conductor on the other side of the outlet box. The
splices after being made should be turned upward and
pushed carefully up into the outlet box.
14
Install remote receiver into the
mounting bracket.
11
Ready for wiring.
12
Canadian mounting only
assembly
pre-attached
blade brackets. Tighten
securely.
