Montarbo MT160P, Инструкция по эксплуатации

Страница: 11 / 21

MT160P
11
Control and connection panel
ENGLISH
1
Input/link jack sockets: they are best suited
as for mobile (touring) applications or when it is
expected to frequently disconnect the system.
The two sockets are parallel connected. Use one of
them (at your choice) for connection to the power
amplifier or the powered mixer output.
Use the otherone‚ if needed, for parallel connection
of another speaker system.
Never connect two power amplifiers to the
same speaker system: doing this may result in
serious damage to the amplifier.
PROGRAMS
POWER HANDLING 90W
IMPEDANCE 8
FREQUENCY RANGE 70Hz - 19kHz
SENSITIVITY 96dB SPL (1W/1m)
music flat
voice
INPUT
MONITOR SPEAKER SYSTEM
Montarbo
MT 160
PROGRAMS
POWER HANDLING 90W
IMPEDANCE 8
FREQUENCY RANGE 70Hz - 19kHz
SENSITIVITY 96dB SPL (1W/1m)
music flat
voice
INPUTS
SERIAL N. MADE IN ITALY
1
2
3
1
GND = Ground
2
+ = Hot
UNSCREENED
JACK
CONNECTOR
1
GND
2
+
2
+
1
GND
2
Colour coded binding posts: they are best
suited for permanent installations. They accept
stripped wire ends or insulated spade lugs
(terminals). When using stripped wire, carefully
check that the wire is completely inserted in the
terminal, and that no free copper strands (which
may lead to short circuits) are left.
Always check that the correct polarity is respected.
3
PROGRAMS selector: allows changeing the
system response to three typical operating
conditions.
☛
See PROGRAMS control examples at page 12