RMD801 - RMD801BH
| Owner’s manual
11
Press the UP/DOWN button on the front of the receiver to choose an available channel.
The channel number will increase by two digit, from 00-99. Once the last channel has been reached, the count will cycle
back to 00.
Press and hold the UP/DOWN button for 2 seconds to send the channel information to the transmitter via infrared trans-
mission.
Press and hold the UP button the display channel will be fast forward.
Press and hold the DOWN button the display channel will be fast backward.
Position the transmitter about 15~30 cm from the front of the receiver with the transmitter IR window facing the IR
transmitter on the front panel of the receiver.
Press and hold the receiver UP/DOWN button to set the transmitter to the same channel as the receiver via infrared
transmission.
When the transmission is complete, the receiver will receive RF signal and tone key from the transmitter.
The A/B indicator will light on the front panel of the receiver.
Turn on your connected amplifier or mixer, but keep the volume all the way down. Set the Level knob on the receiver fully
clockwise. This is unity gain.
Speak or sing into the microphone, or if you are using the transmitter with a connected instrument, play the instrument
at normal performance level. Slowly raise the volume of your amplifier or mixer until the desired level is reached.
If you find the system has noticeable dropouts, reduced overall working range, or unexpected noise bursts, change the
operating channel of the system using the steps above.
ANT.A
LEVEL
ANT.B
POWER
PLL UHF DIVERSITY RECEIVER
ANT.A
LEVEL
ANT.B
POWER
PLL UHF DIVERSITY RECEIVER
ANT.A
LEVEL
ANT.B
POWER
PLL UHF DIVERSITY RECEIVER
