RMD2400 - RMD2400HD
| Owner’s manual
9
RMD2400 - RMD2400HD
7
BODYPACK TRANSMITTER
C
A
1
2
3
4
B
6
7
1
1
2
3
4
5
6
D
C
A
B
D
5
Antenna
It is a flexible antenna. To get effective transmission, never cover the antenna with hand, clothes, etc. during operation,
and always position the transmitter nearby the receiver.
LED Indicator:
on --- the
RMD2420
is on or/and in pair
off --- the
RMD2420
is off
blinking --- in pairing status or short of power
POWER/PAIR Button
- Power on/off the
RMD2420
by pressing and holding for about 5 seconds
- Pair the transmitter and receiver by pressing and holding for about 5 seconds
MINI 4P Connector
This connector is used to connect the unit with the
RDM2430
headset microphone.
Pin 1: GND
Pin 2: Phantom power supply for condenser microphone
Pin 3: For guitar, bass and keyboards
Pin 4: For dynamic or condenser microphone
RDM2430
headset microphone
Preset Impedance: 680 Ω
Frequency Response: 50 Hz ÷ 12 kHz
Sensitivity: -65 dB ± 3 dB at 1kHz
Directional: 12 x 180 mm ( 0.47” x 7.1”)
Weight: 22g (0.049Ib)
GAIN Level Control
The gain level can be adjusted by using the supplied driver to rotate the control.
Driver
This driver can be used to adjust the gain of the body pack transmitter.
Battery compartment
Two alkaline AA batteries are recommended. When inserting the battery, observe correct polarity as marked inside the
battery compartment. Please stop using and change batteries when the led is blinking (not in the pairing status) hich
indicates short of power.
8
8
