Owner’s manual
|
REBEL
12
BLuEtootH
®
ios pRocEDuRE
iPhone
®
– iPad
®
procedure
[1] From the Settings menu > activate bluetooth
®
on your Apple
®
device > ‘I’ > Devices > Looking for ...
[2] Set the potentiometers and MP3 Master Volume in central position. It’s necessary to listen the tones issued by MP3/BLUETOOTH section.
[3] Switch on the REBEL unit by pressing the DC switch to “I” (if the unit is connected to 220/240V AC, please press even the AC switch to “I”).
[4] Pressing the MODE button (by default the MP3 player is turned on) the REBEL display shows the message “Bluetooth Initializing ...”.
A tone (bup) is issued, and the detection procedure starts.
[5]When the external device is identified, the REBEL emits a sequence of two tones (bup - bup) and your iPhone
®
or iPad
®
“Devices” menu
shows BLUETOOTH (in upper case). It means that the Apple
®
device is synced with the REBEL. In this case, proceed to the connection as
explained in step [11].
[6] If the REBEL display shows “Unconnected”, please repeat steps [4] and [5].
[7] If after 3 attempts the REBEL display still shows “Unconnected” turn off the REBEL placing the DC switch to “0”.
[8] Before turning on again the REBEL, delete or ignore other bluetooth devices already present on the Apple
®
unit.
Menu “Devices” > blue arrow click “Forget this Device”.
[9] Wait for 5 seconds, then power on again your REBEL pressing the DC switch to “I” position.
[10] Repeat the steps [4] and [5].
[11] To connect both devices press “not connected” from the external device. Once connected, the REBEL emits a tone (beep) and display
shows the message “Connected”.
[12] Now you can send any signal to REBEL through the Bluetooth
®
connection.
Apple®, iPad® and iPhone® are trademarks of Apple Inc., registered in the U.S. and other countries.
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Elettronica Montarbo srl is under license.
