Montarbo 218 SA, Инструкция по эксплуатации

Страница: 13 / 22

active subwoofer
218SA
Preparation of the power cable for the Power Con
®
connector:
Strip the cable for 20 mm of length and strip each wire for
8 mm of length . We suggest to use a power cable with
1,5
÷
2mm
2
section wires (the insert terminals can however
support a cable with wires up to a section of 4mm
2
/12AWG).
Insert the power cable into the bushing and into the chuck
(white chuck for a cable diameter of 5
÷
11mm; black chuck
for a cable diameter of 9.50
÷
15mm).
Fit a ferrule at the end of each wire and connect wires on
the insert
The wire ends can be clamped in the terminals using an Allen
wrench or soldered by always paying attention to the
symbols shown on the connector: L (Live - corresponding to
the brown wire), N (Neutral - corresponding to the light blue
wire) and (Ground - corresponding to the yellow and
green wire).
After connecting the wires to the insert, lead the cable
through the body and screw down the body with the
bushing.
To make this operation easier, the unit is supplied with
an assembled power cable from which, after checking
the wiring, you can remove the connector and use it to
make a cable suitable for your requirements.
Important !
POWER CON
®
CONNECTOR
HOUSING
BUSHING CHUCK
CABLE
FERRULES FOR
STRANDS
SETSCREWS
N
L
INSIDE VIEW
INSERT
WIRES
CABLE WIRES
20 mm
8 mm
13
ENGLISH