30
THE FOLLOWING STEPS ALLOW FOR PROPER CALIBRATION OF YOUR MONSTER THX SELECT CERTIFIED
SPEAKER SYSTEM. TO COMPLETE THE CALIBRATION OF THE SYSTEM YOU WILL NEED THE OWNER’S MANUAL
INCLUDED WITH YOUR AV RECEIVER. ALL RECEIVERS ARE DIFFERENT AND THE STEPS FOR SETUP
AND CALIBRATION SHOULD BE FOLLOWED CLOSELY.
Subwoofer Levels and Balancing
The first step in calibration is to set and balance the subwoofers and/or Bass Modules, especially important in
systems containing two or more subwoofers and/or Bass Modules. Be sure to set the output of your subwoofers
and/or Bass Modules first before calibrating the rest of the system.
NOTE:
Each Monster THX Select Certified subwoofer and Bass Module has a “THX” selection switch—this switch
will bypass the gain and crossover controls for the low level when set to the THX position. It is recommended
for systems that will play movies only have the switch set to the THX position to simplify system calibration.
Proceed to “Connecting Your Tower Bass Module 200 and Subwoofer 200” Section if your subwoofers or Bass
Modules are set to the THX position.
Switch Settings
When using multiple subwoofers the mode switch is used to maintain proper signal to all subwoofers if the internal
gain is bypassed (THX Setting). The “SUB” position does not have multiple settings as the gain control will maintain
proper signal.
Set the THX switch to the correct setting to get proper output levels.
“THX”
- Use for a single subwoofer
“THX2”
- Use for dual subwoofers with both subwoofers set to this position
“THX4”
- Use for four subwoofers with all subwoofers set to this position
Subwoofers
1. Turn off the amplifiers/AV receiver or disconnect monitor speakers.
2. Set the subwoofer output level of your AV receiver to 0.
3. Turn on one of the subwoofers.
4. Start with the crossover control and bass gain control at the 12 o’clock position.
5. Play a 2-channel music cut and turn up the volume of your AV receiver to a comfortable level.
6. Slowly turn the crossover knob counter clockwise until vocals are muted or are no longer heard.
7. Turn off the subwoofer and repeat steps 2-6 for any additional subwoofer in your system.
8. After calibration is completed in your AV receiver, listen to some music and movies cuts
and adjust gain levels accordingly.
SPEAKER TUNING, CALIBRATION & BALANCING
SPEAKER TUNING, CALIBRATION & BALANCING
Содержание THX Select SL-STAND 100
Страница 1: ......
