Monster THX Select SL-STAND 100, Руководство пользователя

Страница: 31 / 38

27
Bi-Wire / Bi-Amp Connection
If you wish to use separate amplifier channels for the highs and mids of your Monster THX Select Certified Speakers,
remove the jumper straps between the terminals and connect the high-pass and low-pass connections between
the appropriate positive and negative terminals on both bi-amp and speaker.
Connecting Your Monitor
100 or 200 Speakers to
Your Tower Bass Module 200
Your Monitor 100 or 200 speakers can receive
audio signal through special conductive spikes
when placed on top of a Monster THX Select
Certified Tower Bass Module 200 already
connected to the amplifier/AV receiver via speaker
terminals (as shown).
When using the conductive spikes for connection,
double-check the spikes to make sure they are
secure for the best possible connection.
NOTE: Connection through the conductive
spikes and spike rests will not work
if the Bass Module is connected via the
subwoofer low level input. In this case,
the Monitor 100 or 200 must then be
connected directly to the amplifier.
Proper Use of Non-Conductive Spike Covers
If placing the Monitor 100 or 200 on the Tower Bass Module 200 when using a line level connection,
the non-conductive spike covers must be placed over the Monitor 100 and 200 spikes. This prevents
the signal from the Monitor 100 and 200 being sent to the Tower Bass Module 200.
High
Pass
Low
Pass
SPEAKER CONNECTIONS
NOTE : Remove the jumper straps
between the terminals