Monster ICRUZE INTERFACE CABLE MPC FX IM-MB1, Инструкция по установке и эксплуатации

Страница: 17 / 24

to mount the iCruze unit. (An MECP certified installation professional
can also help.)
To prevent cutting the car’s wire harness, a T-Tap-type connector
is recommended (be certain to use the proper size T-Tap to ensure
a reliable connection).
Step 9
On the iCruze Interface Cable there
is a blue/white striped wired that
goes between both ends of the
cable. In the middle is a connector
that comes apart. Pull the ends to
disconnect them. The female end
is not used and can be left alone.
Step 10
Cut off the male “bullet” end and connect it to 12-volt
accessory power.
FINAL NOTE
In very rare instances, the factory fiber optic connector is not
plugged in the factory radio. The entire audio system will continue
to function but the iCruze will not respond. If after a complete
installation, you get no sound from iCruze, check to be sure the
factory fiber optic connector is plugged into the radio. Power cycle
the ignition and radio to ensure a proper reboot if the connector
was not plugged into the radio.
Step 9