Figure 2
Figure 3
STEP 2
Outlet Programming
All PowerSource's outlets located on the rear panel are "programmable". This means in order to program each outlet pair,
you must use the front panel buttons "MENU" and "SET" (figure 2). These buttons enable you to program between "switched
on", "switched on after delay" and "unswitched (always on)" settings independently on each outlet pair. You can change the
settings, when necessary.
, the following diagrams
illustrate how to program the outlets:
Press "ON/OFF" once to power on the unit. The unit will start the power on process
Once the process is finished, the display will show the main line voltage similar to figure 2.
The power-on process may take up to 60 seconds since any outlet pair can be configured as "Switched on after
delay". You can see the outlet pair power status LED from the front panel LED refer to page 16).
Press "MENU" until the display shows the status of AUDIO outlet pair.
Press "SET" button until the DELAY TIME changes to "0"(zero), the display will shows figure 3.
Using the outlet pair labeled as "AUDIO FILTER" as an example
A) Power up the PowerSource:
.
Note:
(
B) Set Outlet Pair to "Switched On":
This "0"(zero) delay time setting indicates the "Switched On" mode for AUDIO outlet pair. This outlet pair will be live
once the PowerSource is switched on by pressing the front panel "ON/OFF" button, or by external signal.
6
