12
When the vacuum is in Sleep mode, press the Clean button once to enter
Standby mode.
When the vacuum is in Standby mode, press and hold the Clean button for
about three seconds to enter Sleep mode.
When the vacuum is in Standby mode, it will automatically enter Sleep mode if
no buttons are pressed for 60 seconds.
Cleaning
Perform the following steps to manually begin cleaning.
1.
Ensure that the Power Switch on the side of the vacuum is in the on position.
2.
Press the Clean button on the vacuum to enter Standby mode. If the vacuum is
on the charger it will begin cleaning right away in Normal mode. Otherwise,
press the Clean button again to begin cleaning.
3.
While cleaning is in progress, use the remote control to control the vacuum's
cleaning behavior.
Press the Clean button on the remote to stop cleaning and re-enter
Standby mode. Press it again to start Normal cleaning again.
Press the Mode button on the remote to cycle through Normal, Spot, and
Edge cleaning modes.
Press the Spot button on the remote to immediately enter Spot cleaning
mode. After it is finished cleaning the spot, the vacuum will automatically
re-enter Normal cleaning mode.
Press the Home button on the remote to cause the vacuum to return to
the Charging Station to begin charging.
While in any cleaning mode, use the Directional buttons on the remote to
alter the vacuum's cleaning path. Use the left and right buttons to change
the path to the left or right. Use the back button to cause the vacuum to
back up. Use the forward button to straighten out the vacuum's cleaning
path. The center button has no function.
When cleaning is complete or when the battery level is low, the vacuum
will automatically return to the Charging Station to begin charging.
