Monogram ZIS360N, Руководство по проектированию с инструкциями по установке

Страница: 13 / 20

13
Installation Instructions
STEP 5 LEVEL REFRIGERATOR
All models have 4-point leveling. The front is sup-
ported by leveling legs, the rear is supported by
adjustable wheels. Both are accessible from the front
of the refrigerator.
• To level the back of the refrigerator, turn the 7/16"
hex nut located above the front wheels. Turn
clockwise to raise or counterclockwise to lower the
refrigerator.
• For front leveling, use a 1-1/4" open-end wrench.
• Adjust height of refrigerator to match installation
cutout opening 83-1/2" to 84-1/2". The refrigerator
should be level and plumb with cabinetry.
STEP 6 SECURE REFRIGERATOR
TO CABINETRY
Whenever possible, perform this step for anti-tip
security, or when anti-tip brackets cannot be used.
The refrigerator must be secured to prevent tipping
.
• Raise the grille panel to access case trim.
• Drill hole in trim and drive screw through the trim
into adjacent cabinet.
• Follow the same procedure on the opposite side.
Hex Nut Adjusts
Rear Wheels
Leveling Leg
STEP 7 ADJUST DOOR SWING
NOTE: This refrigerator has a 2-position door stop.
When space does not allow the door to swing open
fully to 130
°
, you may change the door swing to a 90
°
opening. Skip this step if door opening is satisfactory
for your installation situation.
• Open the door to view the bottom hinge. Note the
door stop pin locations. The pin is factory installed
in the 130
°
position.
• Close the door. From below, use pliers to unscrew
the door stop and reinstall into the 90
°
position.
Drive Screws
Through Case Trim Into
Adjacent Cabinets
Raise Grille Panel
to Stop Position
90˚
130˚
Hinge
Interior
Door