2
31-11062
Installation Instructions
IMPORTANT SAFETY INSTRUCTIONS
FOR YOUR SAFETY
•
Be sure your oven is installed properly by a
qualified installer or service technician.
•
Be sure the oven is securely installed in a cabinet
that is firmly attached to the house structure. Never
allow anyone to climb, sit, stand or hang on the oven.
•
Make sure the cabinets and wall coverings around
the oven can withstand the temperatures (up to
200°F [93.3°C]) generated by the oven.
WARNING
The electrical power to the
oven supply line must be shut off while line
connections are being made. Failure to do so
could result in serious injury or death.
ELECTRICAL REQUIREMENTS
Rating plate is located on the bottom of the front panel.
We recommend you have the electrical wiring
and hookup of your oven connected by a qualified
electrician. After installation, have the electrician show
you how to disconnect power from the range.
Check with your local utilities for electrical codes
which apply in your area. Failure to wire your oven
according to governing codes could result in a
hazardous condition. If there are no local codes,
your oven must be wired and fused to meet the
requirements of the National Electrical Code, NFPA
No. 70–Latest Edition, available from the National
Fire Protection Association.
Effective January 1, 1996, the National Electrical
Code requires that new, but not existing, construction
utilize a four-conductor connection to an electric oven.
When installing an electric oven in new construction,
a mobile home, recreational vehicle or an area where
local codes prohibit grounding through the neutral
conductor, follow the instructions in the section on
NEW CONSTRUCTION AND FOUR-CONDUCTOR
BRANCH CIRCUIT CONNECTION.
You must use a single-phase 120/208 VAC or 120/240
VAC, 60 hertz electrical system. If you connect
to aluminum wiring, properly installed connectors
approved for use with aluminum wiring must be used.
ELECTRICAL REQUIREMENTS
This appliance must be supplied with the proper
voltage and frequency, and connected to an
individual, properly grounded branch circuit, protected
by a circuit breaker or fuse. See the rating plate
located on the bottom of the front panel to determine
the rating of the product. Use the chart below to
determine the minimum recommended dedicated
circuit protection.
KW Rating 240V
KW Rating 208V
Required Circuit
Size (Dedicated)
9.7 KW–12.0 KW
8.4 KW–10.4 KW
50 Amp
Rating Plate Location