Monogram ZDWC240NBS, Руководство по установке, Страница: 3 / 8

Design Guide
THE INSTALLATION SPACE
The cutout depth must be 24"
The cutout dimensions shown allows for a full door
swing and access to the pull-out racks when installed
as a built-in.
• The wine chiller and beverage center can be
installed freestanding.
• If installing between frameless cabinets, a 1/2" wide
filler strip or side panel may be needed on hinge
side. The filler strip will act as a spacer between the
wine chiller case and adjacent cabinet door swing.
The width of the opening must include the filler
panels.
Note: The door should protrude 1" beyond
the surrounding cabinets.
Additional Specifications
• A 120 volt 60Hz., 15 or 20 amp power supply is
required. An individual properly grounded branch
circuit or circuit breaker is recommended. Install a
properly grounded 3-prong electrical receptacle
recessed into the back wall as shown. Electrical must
be located on rear wall as shown.
Note: GFI (ground
fault interrupter) is not recommended.
PRODUCT CLEARANCES
The wine chiller and beverage center is factory set for
a 110
°
door swing.
When installed in a corner:
• Allow 4" min. clearance on the hinge side for the
90
°
door swing and to allow racks to slide out.
• Allow 10" minimum clearance on the hinge side for
a full 110
°
door swing.
• The door swing is reversible on all models. If
desired, change the door swing before installation.
Choose the location:
• The beverage center or wine chiller may be closed
in on the top and three sides as long as the front is
unobstructed for air circulation and proper access
to the door.
• Do not install the wine chiller where the tempera-
ture will go below 55
°
F (13
°
C) or above 90
°
F
(32
°
C).
• Do not install where it will be subject to direct
sunlight, heat or moisture.
Staining Wood Drawer Fronts
The wood drawer fronts on the wine chiller and
beverage center may be stained to match adjacent
cabinetry.
• The tinted glass will make the stained wood appear
darker. A true color match can be seen only when
the door is opened.
3
90
°
Door Swing
SIDE-BY-SIDE INSTALLATIONS
Increase storage capacity by installing two Monogram
beverage centers or wine chillers together. Or for a
complete refreshment center, install a beverage center
and wine chiller together.
• A side-by-side installation requires a 48" wide opening.
No trim kits required.
• Products must operate from properly grounded
separate receptacles.
20-3/32"
23-11/16"
4" Minimum
to Wall
90
°
Locate
Outlet
34-1/2"-35"
24" Min.
48" Min.
6" Max.
10" Minimum
to Wall
110
°
Locate
Outlet
34-1/2"-35"
24" Min.
24" Min.
23-7/8"
24-1/8"
34-1/4"