Monogram ZDWC240NBS, Руководство по установке, Страница: 2 / 8

Safety Information
WARNINGS:
• Use this appliance only for its intended purpose.
• Immediately repair or replace electrical service
cords that become frayed or damaged.
• Unplug the wine chiller or beverage center before
cleaning or making repairs.
• Repairs should be made by a qualified service
technician.
ATTENTION:
• Il ne faut utiliser cet appareil que pour l’usage
pour lequel il a été construit.
• Il faut réparer ou remplacer immédiatement tout
cordon d’alimentation électrique effiloché ou
endommagé.
• Débrancher le bar ou le réfrigérateur a vin avant le
nettoyage ou toute intervention.
• Les réparations doivent être faites par un
technicien qualifié.
For Monogram local service in your area,
1-800-444-1845
For Monogram service in Canada
1-888-880-3030
For Monogram Parts and Accessories, call
1-800-626-2002.
www. monogram.com
2
BEFORE YOU BEGIN:
Read these instructions completely and carefully.
IMPORTANT
- Save these instructions for
local inspector’s use.
I MPORTANT
- Observe all governing codes
and ordinances.
Note to Installer
- Be sure to leave these instructions
with the Consumer.
Note to Consumer
- Keep these instructions with
your Owner’s Manual for future reference.
WARNING -
This appliance must be
properly grounded. See “Electrical Supply” page 4.
ATTENTION -
Cet appareil doit être
correctement mis à la terre. Consulter
<<Alimentation électrique>>, page 4.
If you received a damaged wine chiller or beverage
center, you should immediately contact your dealer or
builder.
Skill Level -
Installation requires basic mechanical
skills. Proper installation is the responsibility of the
installer. Product failure due to improper installation is
not covered under the GE Appliance Warranty.
CONTENTS
Design Guide
The Installation Space .................................... 3
Product Clearances ........................................ 3
Side-by-Side Installation ................................ 3
Installation Instructions
Tools, Hardware ............................................... 4
Grounding the Product ................................... 4
Step 1, Remove Packaging ............................ 4
Step 2, Reverse Door Swing .......................... 5
Step 3, Leveling ................................................ 6 Step 4, Connect Power ................................... 6
Step 5, Slide Product into Cutout .................. 6
Step 6, Install Badge ....................................... 6
Step 7, Set Temperature Controls ................. 6
Template for Badge ...................... Back Cover