Monogram ZDIC150, Руководство по проектированию с инструкциями по установке, Страница: 14 / 18

14
Installation Instructions
Install the new drain tube with the new 7/8” clamps.
1. Place rear cover against the back of the ice
machine. Route the vent tube, power cord, drain
tube, and water supply line through cut outs in
the rear cover.
2. Secure rear cover with original screws.
Attach vent tube to unit with clamps as shown.
3. Trim one end of hose at 3/4” diameter. Secure
5/8” diameter section to pump with 7/8”
adjustable hose clamp
4. Route drain tube to house drain.
STEP 5 - INSTALL BIN DRAIN TUBE
STEP 6 - SECURE VENT TUBE
NOTE: While performing installations described in this
book, safety glasses or goggles should be worn.
NOTE: Product improvement is a continuing endeavor at
General Electric. Therefore, materials, appearance and
specifications are subject to change without notice.
7/8”Adjustable
Hose Clamp
Water Supply
Vent
Tube
1/2” Drain tube
Power Cord
Clamps and Screws
New 5/8” Drain Tube
New 7/8” Adjustable
Hose Clamp Installed
1. Carefully slide the auxiliary drain pump into the
bottom of the ice machine. The tab on the back of
the pump should slip into the rectangular slot on
the ice machine floor. It may be necessary to tip
the pump slightly to engage the tab.
NOTE: The pump must be in position before
connecting the bin drain tube. Slide pump tab into
floor slot in the bottom of the cabinet. See Step 5.
2. Secure the pump to the base with the 2 supplied
screws.
STEP 4 -INSERT DRAIN PUMP
Mounting Tab Slot
Pump Mounting Screws