❏
17. Cement sissy bar 16 into frame with large
notch in bar towards front as shown. Make
sure the sissy bar is on as far as it will go.
❏
18. Cement fender 17 onto pins on frame and
cross piece on sissy bar.
❏
19. Next cement seat back into seat.
❏
20. Now cement assembled seat to fender with
pins on fender fitting into seat.
5 7541
4
❏
21. Crankcase halves 20
H
and 21
H
together.
❏
22. Cover 22 to side of crankcase.
❏
23. Oil pump 23 to crankcase.
❏
24. Generator 24 to housing 25
H
then
cement to back side of cover 22.
❏
25. Pushrod plates 26 and 27 on
crankcase with tabs fitting onto
slots.
❏
26. Cylinder halves 28
H
, 29
H
, 30
H
and
31
H
together, then cement to top of
crankcase.
❏
27. Timer 32 onto large pin on side of
cylinder.
❏
28. Half round pins on ends of four push
rods 33 into holes in covers 34
H
.
❏
29. Tabs on covers 34
H
into slots in top
of cylinders and fit bottom of push
rods into holes in plates 26 and 27.
❏
30. Carburetor halves 35 and 36
together.
❏
31. Large pin on carburetor into hold in
air cleaner 37.
❏
32. Completes careburetor onto pad
between cylinders.
❏
33. Two spark plugs 38
H
into holes in
cylinders at an angle as shown in
illustrations “A”.
5
38
D
32
E
33
E
24
B
16
C
18
B
22
E
23
E
27
E
26
E
35
E
33
E
37
E
36
E
17
C
19
B
34
H
34
H
30
H
31
H
29
H
28
H
25
H
20
H
21
H
LARGE
NOTCH
CROSS
PIECE
ANGLE
AS SHOWN
ILLUSTRATION
"A"
