17
The following pharmaceutical reduction claims have not been certi¿ed by NSF International or the state of California.
Claims tested and veri¿ed by independent laboratory:
Contaminant
Reduction
AvHUDJH,Q¾XHQW
16)VSHFL½HG
Challenge Concentration
Avg %
Reduction
Average Product
Water
Concentration
Max Permissible
Product Water
Concentration
NSF Reduction
Requirements
NSF
Test Report
Atenolol
978 ng/L
N/A
99.5%
5.0 ng/L
N/A
N/A
J-00121587
Fluoxetine
907 ng/l
N/A
99.4%
5.4 ng/L
N/A
N/A
J-00121587
Ibuprofen
885 ng/L
N/A
94.1%
52.3 ng/L
N/A
N/A
J-00121588
Progesterone
1097 ng/L
N/A
99.5%
5.0 ng/L
N/A
N/A
J-00121589
Trimethoprim
415 ng/L
N/A
99.5%
2.0 ng/L
N/A
N/A
J-00121587
It is essential that the manufacturer’s recommended installation, maintenance and filter replacement requirements be carried out for the product to perform as advertised.
See Installation Manual for Warranty information.
Application Guidelines/Water Supply Parameters
Service Flow
0.5 gpm (21.9 lpm)
Water Supply
Potable Water
Water Pressure
40-120 psi (2.8-8.2 bar)
Water Temperature
33°F-100°F (0.6°C-38°C)
Note:
While the testing was performed under standard laboratory conditions,
actual performance may vary.
Replacement Cartridge: MWF. For estimated costs of replacement elements
please call 1-800-626-2002 or visit our website at www.geapplianceparts.com.
WARNING
To reduce the risk associated with ingestion of contaminants:
• Do not use with water that is microbiologically unsafe or of unknown quality
without adequate disinfection before and after the system. Systems cert
L¿
ed
for cyst reduction may be used on disinfected water that may contain
¿
lterable
cysts. EPA Establishment Number 10350-MN-005.
NOTICE
To reduce the risk associated with property damage due to water leakage:
• Read and follow use instructions before installation and use of this system.
• Installation and use MUST comply with all state and local plumbing codes.
• Do not install if water pressure exceeds 120 psi (8.2 bar). If your water pressure
exceeds 80 psi, you must install a pressure-limiting valve. Contact a plumbing
professional if you are uncertain how to check your water pressure.
• Do not install where water hammer conditions may occur. If water hammer
conditions exist you must install a water hammer arrester. Contact a plumbing
professional if you are uncertain how to check for this condition.
• Do not install on hot water supply lines. The maximum operating water
temperature of this
¿
lter system is 100º F (38º C).
• Protect ¿lter from freezing. Drain
¿
lter when temperatures drop
below 33ºF (0.6ºC).
•
must be replaced every 6 months at the
rated capacity, or sooner if a noticeable reduction in
ÀR
w rate occurs.
For conditions of use, health claims certified by the California Department of Public
Health, and replacements, see performance data sheet. California Department
of Public Health Certification #05-1698. The contaminants or other substances
removed or reduced by this water filter are not necessarily in all users’ water.
Tested and cer
WL½
ed by NSF International
against NSF/ANSI Standard 42 and
Standard 53 in model GE MWF for the
reduction of the claims speci
½H
d on the
performance data sheet.
REPLACEMENT
ELEMENT
Performance Data Sheet
SmartWater
™
Filtration System
³
GE MWF Cartridge
Performance Data Information
Capacity: 300 Gallons (1,135 Liters)
7KHFRQFHQWUDWLRQRIWKHFRQWDPLQDQWVWHVWHGIRUWKLV¿OWHULQZDWHUHQWHULQJWKHV\VWHPZDVUHGXFHGWR
DFRQFHQWUDWLRQOHVVWKDQRUHTXDOWRWKHSHUPLVVLEOHOLPLWIRUZDWHUOHDYLQJWKHV\VWHPDVVSHFL¿HGLQ
16)$16,6WDQGDUGDQG6WDQGDUG6\VWHPWHVWHGDQGFHUWL¿HGE\16),QWHUQDWLRQDODJDLQVW16)
ANSI Standard 42 and Standard 53.
Please see geappliances.com for complete listing of the contaminants tested and the amounts reduced
