Monitor Technologies LLC
44W320 Keslinger Rd.
t
Elburn, IL 60119
t
630-365-9403
t
800-766-6486
t
Fax: 630-365-5646
t
www.monitortech.com
B U L L E T I N
344H
SAFET Y
Monitor Technologies LLC warrants each
Wireless
EZ
Communications Interface it manufactures to be free from
defects in material and workmanship under normal use and
service for two (2) years from the date of purchase. The pur-
chaser must notify Monitor of any defects within the warranty
period, return the product intact, and prepay transportation
charges. The obligation of Monitor Technologies LLC under this
warranty is limited to repair or replacement at its factory. This
warranty does not apply to any product which is repaired or
altered outside of Monitor Technologies’ factory, or which has
been subject to misuse, negligence, accident, incorrect wiring by
others, or improper installation. Monitor Technologies LLC
reserves the right to change the design and/or specifications
without prior notice.
WARRANT Y
Power Requirements: 85 to 265 VAC (±15%); 8VA;
50/60Hz
Ambient Operating Temp: -40° to +150° F (-40° to +65° C)
Data Input Signal: RS-485 half-duplex, isolated
Wiring Distance: 3,279 ft. (1,000m)
Radio Output: 900MHz (North America); 1W
Radio Sensitivity: -110dBm
Conduit Entry: Two 0.88in (22.4mm) dia. holes
Indicators: Orange LED: Tx
Yellow LED: Rx
Green LED: Power
Housing: Powder coated die cast aluminum,
IP66
Mounting: Wall or pipe/rail
CHINA RoHS 2
SPECIFICATIONS
MECHANICALS
WirelessEZ Communication Interface
Left: Standard Antenna
Center: high Gain Antenna
Right: Yagi Antenna
DIMENSIONS ARE ShOWN IN INChES WITh MILLIMETER EqUIVALENT IN BRACkETS
General Safety:
CAUTION!
It is essential that all instructions in this man-
ual be followed to ensure proper operation of the equip-
ment and safety of operating personnel. The use of this
symbol is used throughout manual to highlight important
safety issues. Please pay particular attention to these
items.
Electrical Shock Caution:
Certain
Wireless
EZ
Communication Interfaces are pow-
ered with HIGH VOLTAGE. No operator serviceable parts
are inside. All servicing is to be performed by qualified
personnel. Each
Wireless
EZ
Communication Interface is
provided with a “protective conductor terminal” which shall
be terminated to earth ground potential (See Electrical
Installation). This product's design complies with
EN61010-1 overvoltage category II and pollution degree
2. When installing certain high performance antennas, it
is critically important that the antenna not come in contact
with overhead power lines. Doing such may put operators
at risk of electrical shock that may be harmful or fatal.
Electromagnetic Compatibility (EMC):
The
Wireless
EZ
Communications Interface contains
transmitter module FCC ID: OUR-9XTEND. This enclosed
device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions.
1. This device may not cause harmful interference
2. This device must accept any interference received,
including interference that may cause undesired
operation.
GDR
JSC
MAY 19 2017
DOC-001-344H 4
Содержание WirelessEZ
Страница 6: ...6 Figure 9...
