8
© Monitor Audio 2006 BRW-10 Rev4
6. Power Mode Switch with On-Auto-Off Facility
The Power Mode Switch has three positions: ‘On’–‘Auto’–‘Off’. When the switch
is in the ‘Off’ position the subwoofer will not function. In the ‘Auto’ position the
subwoofer will automatically switch on when an input signal is received. It will
remain on. If no signal is received for around 15-20 minutes, the BRW-10 will
then switch into standby mode until a signal is received once more. With the
switch in the ‘On’ position, the subwoofer is permanently switched on under all
conditions.
7. Warning Information
The following warning symbols are found on the amp panel. The meanings are:
This lightening flash with an arrow head symbol, within an equilateral
triangle, is intended to alert the user to the presence of uninsulated
“dangerous voltage” within the products enclosure that may be of
sufficient magnitude to constitute a risk of electric shock to the persons.
Warning: To reduce the risk of electric shock, do not remove cover
(or back) no user-serviceable parts inside.
Refer servicing to
qualified service personnel
This exclamation point within an equilateral triangle is intended to alert
the user to presence of important operating maintenance (servicing)
instructions in the literature accompanying the appliance
8. Mains Power Switch
The Mains Power Switch should be switched to the ‘Off’ position when the BRW-
10 will not be used for extended periods. The switch must be in the ‘On’ position
for the sub-woofer to function.
WARNING:
Due to the mains switch being located on the rear panel, the
apparatus must be located in the open area with no obstructions to access the
mains switch.
9. Mains Voltage Selector
This is factory set to your country’s mains voltage specification. Do not attempt to
adjust this as this may lead to permanent damage to the product and even the
risk of fire.
10. IEC Mains Power Connector/ Fuse Location
The BRW-10 is supplied with a two-pin mains input socket for connection to the
mains supply. Use ONLY the appropriate IEC mains lead provided with the
product. Also fitted is an external mains fuse. If a fuse blows during operation a
spare fuse is provided within the fuse holder for replacement. If you wish to
change the fuse, you can do this by removing the IEC mains lead and carefully
levering out the original fuse from its holder below the IEC mains input socket
(10a). If the fuse blows again it is advisable to seek help from an authorised
service agent.
DO NOT attempt to re-fit a further fuse as this could result in
serious damage to the amplifier unit.
