Specification
Low frequency limit:-
27Hz (EQ1) 21Hz (EQ2)
Upper frequency limit:-
40 – 120 Hz Variable
Low pass filter alignment:-
Active 4th order 24db/octave (two-stage filter)
Cabinet Specification: -
Sealed Cabinet of 25mm M.D.F construction with internal bracing
Amplifier Output:-
500 Watts (RMS) 1000 Watts (Peak)
Amplifier classification:-
Class- D Digital amplifier
Driver compliment:-
1 x 12” C-CAM
®
subwoofer driver featuring triple suspension and 3”
long throw voice coil
Dimensions:-
Millimetres:- 340 x 340 x 370
(H x W x D)
Inches:-
13
3
/
8
x 13
3
/
8
x 14
½
Weight (unpacked):-
25.5 Kg (56lbs)
Input Impedance: -
20K Ohms
Mains input voltage:-
110 - 120 Vac / 220 - 240 Vac 50/60Hz
(Electronically Auto selected)
C-CAM® is a registered trade mark of Monitor Audio Ltd
Trouble Shooting
Should you experience any technical, or set-up problems with your AW-12 please check the Trouble Shooting
Guide below:
My AW-12 will not turn on/no power.
• Is the LED illuminated on the back of the unit? If not, then check your mains lead is properly connected
both at the AW-12 and at the mains outlet. Also check the fuse of the mains plug (where fitted) and also
the fuse in the AW-12. See page 7 for further information on changing the fuse and it’s location.
• Is the LED on the back red? If so, you have power going to the unit. It could be that there is no signal,
or the 12v trigger is connected and the source not turned on (see below).
• Have you got the 12v trigger connected? If so, the AW-12 will not power up until the source is powered
up.
• Has it got a signal going to it (12v trigger not being used)? If so, is the Power Mode Switch in the Auto
or On position, and the signal source is turned on? Try adjusting the volume level of the source.
If it still does not turn on/ power up, please contact your local dealer/ distributor or Monitor Audio immediately.
No sound from AW-12.
• Is the LED on the back red or green? If it is red, then the unit hasn’t actually turned on. See above
comments. If it is green, then your unit is powered up and turned on. Check further suggestions
below.
• Are the signal leads connected correctly? Check these. If possible, check with a second, known to be
working set.
• Is the volume level just very low?
If it still does not output a signal, please contact your local dealer/ distributor or Monitor Audio immediately.
monitoraudio.co.uk
9
