Monit Rally G-100+, Эксплуатация и установка

Страница: 10 / 23

18 19
Wheel Sensor Mode Setup
If you want to use a traditional wheel sensor instead of the GPS/GNSS
system to measure distance and speed you will have to disable the GPS/
GNSS receiver and perform a calibration of the wheel sensor against a known
distance before the unit can be used. After powering up the unit and selecting
a default operating language (this can be changed later on) the setup can be
performed using the menu system.
To disable the GPS/GNSS receiver, select ‘GPS Setup’ in the main menu and
toggle the ‘Enable’ option to the off position.
Next you will need to perform a calibration. If you already know the pulse/km
calibration value for your vehicle, you can also enter this value directly. Refer to
page 36 for details. Otherwise continue to the next page.
Distance Calibration
If the GPS/GNSS is not being used, you will need to perform a calibration of
the wheel speed sensor before it can be used. The device includes a special
calibration wizard that guides you through this process using simple on-screen
instructions.
To calibrate the distance:
Find a piece of road with an accurately known distance. Use a distance of 1.
at least one mile/kilometre for best results.
From the Main Menu select Calibration > Cal. Distance to start the 2.
calibration wizard.
Follow the instructions on the screen. 3.
Note: The device will not lose its calibration if the power supply is disconnected.
Getting Started - Wheel Sensor Mode Getting Started - Wheel Sensor Mode