Moni HEB-999, Инструкция по эксплуатации

Страница: 15 / 22

PARTS DIAGRAM
The assembly must be performed by an adult, which takes about 20 minutes. Notice: Some parts may be pre-
assembled at the factory.
1 Body
2 Driving wheel (rear)
3 Front wheel (flat)
4 Windshield
5 Rear spoiler
6 Seat
7 Steering wheel
8 Side mirror
9 Hubcap
10 Remote control
11 Charger
12 Screw
13 Nut
14 Seat knob
15 Washer
14
ASSEMBLY STEPS
1. Driving wheel installation – FIGURE 1:
• Mount in the following order on the rear axle:
Motor

Wheel

Hubcap.
2. Front wheels installation – FIGURE 2:
• Observe the instructions and place in the following order:
Washer

Wheel

Hubcap.
3. Steering wheel installation – FIGURE 3:
Connect the bushing of the steering wheel and the bushing of the car. Place the steering wheel in the upper end of the
steering shaft, which comes out of the car’s body. Align the openings of the steering wheel and the steering shaft,
designated for the fixing screw. Insert the machine screw through the openings of the steering wheel and steering shaft and
fasten it with the nut and the screwdriver.
4. Windshield installation – FIGURE 4:
Place the windshield on its intended position on the car’s body. Align the openings of the car’s body with those of the
ornamental frame, which are intended for the fastening screws. Afterwards with the help of the screws fasten the frame to
the body .
5. Spoiler installation – FIGURE 5:
Place the spoiler on its intended position on the car’s body.
• With the help of the screws fasten to the body.
6. Side mirrors installation – FIGURE 6:
Place the side mirrors at their intended positions on the car’s body. Press carefully down, until you hear a clicking sound
signifying their fastening.
7. Connecting the battery operated car’s cables:
Connect the bushing of the red cable with the red terminal. DO NOT CONNECT BLACK BUSHING WITH RED TERMINAL.
8. Seat installation – FIGURE 8:
Remove the screws of the place for the seat on the car’s body. Place the seat, the plastic pins of the rear part of the
backrest must fit the respective openings of the car’s body. Press carefully down, until the seat is fastened. Fix it with the
screws you removed earlier and the seat knob. Do not overtighten the screws, in order to avoid damaging any of the parts.