Moni AUDI R8 SPYDER, Инструкция по эксплуатации

Страница: 17 / 23

9 Lock nut 4
10 Hubcap 4
11 M5x16 machine screw 2 for seat
12 Seat 1
13 Mirror 2 Left and right
14 Steering wheel 1
15 M5x35 machine screw 1 Placed on the steering wheel
16 Ø5 nut 1 Placed on the steering wheel
17 Adapter 1
18 Spanner 2
19 Remote control 1 Optional, only for car with R/C
16
DIAGRAM OF THE PARTS
See Figure PD:
NOTICE:
Some of the parts shown are pre-assembled on both sides of the battery operated car.
The type of remote controller may vary
BEFORE ASSEMBLY OF THE PRODUCT
WARNING!
FOR THE SAFETY OF YOUR CHILD, PLEASE, READ ALL WARNINGS AND RECOMMENDATIONS FOR ASSEMBLY
AND USE. KEEP THIS INSTRUCTION MANUAL FOR FUTURE REFERENCE.
• AN ADULT MUST PERFORM THE ASSEMBLY. The product contains small parts, which is the reason the assembly must
be performed by an adult. Children must not be present during assembly.
• remove the safety materials and packaging and throw them after the product is assembled.
• The packaging of the car is not a toy for children. For the purpose of avoiding suffocation or death, keep the plastic
packaging away from children.
Make sure that the power button is in an “OFF” position before assembly of the car.
•Before use for the first time you must charge the battery for at least 4 to 6 hours.
•You will need the following tools:
•On figure T are shown the tools you will need for the assembly.
ASSEMBLY OF THE PRODUCT
• WARNING! The battery operated car must be assembled by an adult.
• Please, take at least 40 minutes for the assembly.
• You must be careful while unpacking and assembling the car. Do not allow children to play with the parts and play during
assembly. They might get hurt due to presence of small parts, sharp edges while the product is not yet assembled.
• Please, separate and identify all parts before assembly; keep all packaging until you are finished in order to avoid
unintentionally throwing away any parts.
• After each step you must check whether the individual parts are correctly placed and installed. Follow strictly the individual
steps and observe carefully the enclosed figures for the assembly.
1.Installation of the rear wheels – See Figure 1:
On Figure 1 are marked with A – the driving wheel, and with B the Rear Axle.
•Turn the car body upside down.
•Remove all the parts from the rear axle.
•Slide the
gearbox on the rear axle (at the right side of the rear axle). The gearbox indicated with “R” is the one which must
be placed on “R” (right side) of the car’s body. The gearbox indicated with “L” is the one which must be placed on “L” (left)
side of the car’s body. The motor and connector of the gearbox must go through the bigger opening in the rear side of the
keep, where the battery is.
•Slide the
driving wheel on the rear axle, the ribs of the gearbox must align with those of the driving wheel ..
•Slide Ø12 washer on the rear axle.
•Place Ø10 safety nut at the end of the rear axle and tighten it with the help of a spanner.