Monessen Hearth DIS33NTG, Инструкция по установке и эксплуатации

Страница: 28 / 40

28
23D8020
W
ARNING
Figure 34 - Location of Piezo Ignitor, Control Knobs and Switch on Milli-Volt Unit,
Hi/Lo Remote Control and Manual Unit
A.
This appliance is equipped with a piezo ignition device which automatically lights the pilot. If the piezo
is not working properly see Match Lighting Instructions on page 30.
B.
BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next to the floor
because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
• Do not attempt to light any appliance.
• Do not touch any electric switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire department.
C.
Use only your hand to push in, or turn the gas control knob. Never use tools. If the knob will not
push in or turn by hand, don't try to repair it. Call a qualified service technician. Force or attempted
repair may result in a fire or explosion.
D.
Do not use this appliance if any part of it has been under water. Immediately call a qualified service
technician to inspect the appliance and to replace any part of the control system and any gas control
that has been under water.
OPERATING INSTRUCTIONS
Piezo Ignitor
On/Off Switch
If you do not follow these instruction
exactly, a fi re or explosion may result
causing property damage, personal
injury or loss of life.
W
ARNING
Control Knobs
Blower
Optional T-Stat
Sensor
FOR YOUR SAFETY READ BEFORE LIGHTING