Monark Compact Rehab 871 E, Руководство пользователя

Страница: 10 / 16

Fig: Brake belt contact surface
Batteries
If the meter is battery-operated, the batteries are in
a separate package at delivery. If the storing time
has been long the battery power can be too low to
make the computer act correctly. Batteries must be
changed.
Brake belt contact surface
Deposits of dirt on the brake belt and on the contact
surface may cause the unit to operate unevenly and will
also wear down the brake belt. The contact surface of
the flywheel should be smoothed with fine sandpaper
and any dust removed with a clean dry cloth.
Remove any covers and loosen the tension on the
brake belt. Smoothe with fine sandpaper. This is
easier to perform if a second individual cautiously
and carefully pedals the cycle.
Irregularities on the brake belt contact surface are
removed by means of a fine sandpaper or an abrasive
cloth. Otherwise unnecessary wear on the brake belt
may occur and the unit can become noisy.
Always keep the brake belt contact surface clean and
dry. No lubricant should be used. We recommend
replacing the brake belt when cleaning the contact
surface. In regard to assembly and adjustment of the
brake belt, see ”Replacement of brake belt”.
Crank bearing
The crank bearing is greased and normally requires
no supplementary lubrication. If a problem arises,
please contact your Monark dealer.
Flywheel bearing
The bearings in the flywheel are greased and do not
normally require maintenance. If a problem arises,
please contact your Monark dealer.
Transport
At transport the brake belt should be tightened to
prevent it from falling off the flywheel.
Replacement of brake belt
To replace the brake belt remove covers if necessary.
Make sure that the belt is loose.
Pendulum bike with engine:
To loosen the brake belt on pendulum bikes with
engine, connect power to the unit and raise the
pendulum to 4 kp. Hold it there until brake belt is
loose. Please note how the belt is assembled. Remove
it from the bike. Attach the new brake belt and
assemble the bike in reverse order.
Weight basket bike:
To loosen the brake cord on cycles with a weight
basket set the basket to its upper position. Loosen the
lock washer that is holding the cord and remove it
from the tension center. Loosen or cut of the knot in
the other end of the cord and then remove the hole
cord from the bike. When assembling a new brake
cord, first enter one end into the hole in the tension
center, and tie a knot and let the knot fall into the
bigger part of the hole. Lock the end of the cord with
the lock washer.
Manual pendulum bike / exercise bike:
To loosen the brake belt on other bikes remove all
possible tension. Please note how the belt is assembled.
Remove it from the bike. Attach the new brake belt
and assemble the bike in reverse order.
NOTE!
When replacing the brake belt it is recommended
to clean the brake surface. See ”Brake belt contact
surface”.
Monark 871 E
10