Monark 939 E, Руководство пользователя

Страница: 10 / 28

2
3
1
1
Monark 939 E
10
Connection to an external unit e.g. ECG device
First check the brake belt tension. If the belt is too
tight loosen it a little by moving the force indicator to
about 4 kp and hold it there for a few seconds. Then
the force-adjusting servo will loosen the belt tension.
To be sure that indicator positions are correct, do a
calibration. See ”Electronic calibration”.
Press the switch(2) to turn off the power, see 1.
fig: Connections . Disconnect the cable from any
connected device.
Adjust the scale mechanically so that 0-index on
2.
the scale and indicator are in line.
Move the indicator to 6 kp and hold it there.
3.
Turn on the power again. (The green LED on the 4.
lower left side of the bike is lit up when there is
power to the bike, see
fig: LED
.)
Hold the indicator at 6 kp until two beeps are 5.
heard.
Move the indicator to the setting that
6.
corresponds with the type of external unit you
are connecting to:
0 = mode for use with PC or hand unit.
1 = mode for Siemens Megacart ECG
2 = mode for other ECG devices, alt 1.
3 = mode for other ECG devices, alt 2.
Hold at this position until two beeps are heard 7.
and after that, move the indicator to 0 again.
The system will now restart in chosen mode.
Reconnect the proper cable between the external
8.
device (ECG Siemens Megacart requires a special
cable) and the bike.
The bike is now controlled digitally from the
9.
external device.
These settings can also be done using the PC or the
terminal. Follow the instructions described in the
respective manuals.
Reset the Ergometer to use with terminal/PC.
Follow steps 1 – 7. At step 7 press ’0’ and then ENTER.
The Ergometer can now be controlled again from the
terminal or an external PC.
Alt. 1: ECG, Ergoline compatible command set,
requested load value.
Alt. 2: ECG, Ergoline compatible command set,
current load value.
Fig: Connections
1) Power connector
2) Serial port connection, external unit
3) Switch (on/off)
Fig: LED (1)
(Left side in front of
rear support tube.)