6
Once the salt level in the pool is correct the Unit may be switched On. The
Stand - by
indicator
will be On and no
Cell Output
will be seen for approx 30 seconds, this allows the pump and
filter to prime and the Cell Housing to fill with water. After this start - up delay the Display
should light up fluctuating around 100, unless in
Winter Mode
where it will fluctuate around 85.
At this point both
Operation LED's
should be Green; if not there is a problem. (Refer table).
DISPLAY/INDICATOR
LED 1
LED 2
REASON/ACTION
STAND – BY
ON
Green
Green
1.
Start – up delay functioning.
2.
System Control
set below max.
Cell is turned off. (Refer
System
Control
page 7).
FLOW
STAND – BY
ON
Green
Green
1.
Gas detected. Check pump/pipes
for damage.
2.
Gas sensor not connected to cell
FLUCTUATING
AROUND 100
Green
Green
System operating normally
Green
Red
1.
Salt level too low. Add salt at a
rate of 25kg per 25000L.
2.
Cell is calcified. Clean cell.
3.
Water temperature low. Switch to
Winter Mode.
Red
Red
1.
Salt Level below minimum. Add
Salt.
2.
Cell is calcified. Clean Cell.
3.
Water temperature very cold.
Switch to
Winter Mode.
Continued Operation may cause
damage to system – Consult dealer
for problem rectification
PLEASE NOTE: When Winter Mode switch is On Unit will operate similar to above except Display will fluctuate
around 85. (Refer Winter Mode page 8).
OPERATION OF CHLOROMATIC
ESC SYSTEM
:
The Chloromatic
ESC system operates similarly to the ESR System described above. The ESC
system has the following additional features:
1.
POLARITY INDICATOR ON OUTPUT Display -
The
±
Symbol
appears before the cell
output display to indicate which polarity the system is in, i.e. positive or negative. This
symbol will alternate and is factory pre set.
2.
SYSTEM CONTROL -
When adjusting the
System Control (refer following section)
the
ESC system’s Cell Output Display flashes the control setting (i.e. percentage of time that the
Cell operates during the filtration cycle) for a few seconds then resumes displaying Cell
Output.
3.
CLEANING OF CELL –
The ESC System uses a patented
Electronic Self Cleaning
system to clean your Cell and therefore you should not have to clean your ESC cell unless
you have extreme water conditions.
