5
CLEANING AND STORAGE
After each use, clean the NasoNeb® Sinus Therapy System.
1. Unplug the Compressor.
2. Disconnect the Cup Assembly from the tubing.
3. Disassemble the Cup Assembly and wash the Cup and Insert
in warm soapy water.
4. Wipe the Tubing and Compressor with a damp cloth.
5. Set components aside to dry between uses.
6. You may rinse the Cup and Insert with hydrogen peroxide or isopropyl alcohol.
Replace Supply Tubing and Cup Assembly with a Model 7080 NasoNeb® Sinus Therapy
System Supply Kit every 6-12 months or every 730 cleaning cycles. Store the NasoNeb®
Sinus Therapy System in a dry place.
Caution
– Avoid the use of harsh detergents or cleaning agents. These may damage
the plastic components, cause fogging or other undesirable effects. Do not wash in the
dishwasher.
Caution
– Do not allow water to enter the Supply Tubing.
Caution
– If water enters or condensation forms in the Supply Tubing, connect one
end of the Supply Tubing to the Compressor and run the Compressor until the water or
condensation evaporates.
REPLACE THE FILTER
The Compressor has a filter installed in the filter holder. There are additional filters
included in the system. Check the filter every 6 months or 720 minutes of use. If it is
dirty, replace the filter. Additional filters can be acquired from Monaghan Medical
Corp. or where you purchased the NasoNeb® System.
1. Pull the filter cover out of the compressor (the cover pulls straight out)
2. Remove the filter from the cover
3. If the filter is discolored, replace with a new filter, otherwise, put the filter back
into the filter cover
4. Insert the filter cover back into the compressor before using
