SET UP AND OPERATION
Follow these simple steps to prepare and operate the NasoNeb® Sinus Therapy System.
SETUP
1. Unpack the tubing. Connect one end to the outlet of the
NasoNeb® Compressor.
2. Unpack the NasoNeb® Sinus Therapy System and assemble by
following these steps:
a. Connect the loose end of the Tubing to the air inlet of the Cup
b. Place the Insert into the Cup to form the Cup Assembly
c. The Insert and Cup fit together in only one orientation.
If the Insert does not seat, rotate the Insert 180 degrees
3. Place the tubing in the tubing holder to hold the Cup Assembly upright
4. Plug the power supply into the Compressor
5. Plug the power supply into the wall
HOW TO USE
1. Place half of the medicine into the Cup Assembly
2. Place the Cup Assembly into one nostril, aim it
straight in or slightly away from the septum (the
middle of your nose that divides your nostrils)
3. Turn on the Compressor
4. Turn o the Compressor when empty
5. Repeat steps 1-4 for the other nostril
TIP:
You may need to tilt your head more or less to find the best angle for your nose
TIP:
You may need to adjust the location of the Cup forward or backward to find the
best location for medication delivery.
TIP:
Stopping after the first few seconds to blow your nose may improve delivery.
NOTE:
Do not turn on the Compressor until the Cup Assembly is in position in the
nose. Do not remove the Cup Assembly from position without first turning o the
Compressor. Doing so may result in being sprayed in the face.
4
Insert
Cup
Supply Tubing
