Monaco 2002 Diplomat, Руководство по обслуживанию

Страница: 277 / 324

The motorhome air braking system is equipped with several back-up
safety systems and warning alarms in the event of an air system failure.
Refinements to air braking systems have been instituted with safety as top
priority. For example: Should the air compressor fail to charge the air system,
and the low air gauge readings go undetected, a low air pressure warning
buzzer will sound and the low air pressure dash warning indicator lamp will
illuminate. These warning indicators occur at approximately 65 psi. This will
alert the operator of an impending situation. If the motorhome is allowed
continued operation, the pneumatic emergency spring brake relay valve
installed in the air system senses the low air pressure condition. The
emergency spring brake relay valve will release the air charge from the
spring brake air chambers on the rear drive axle. In this case the park brakes
will automatically apply at approximately 30 psi. This safety back-up system
acts as an automatic emergency brake system.
Another back up safety is the air system separation of the front and rear
brakes, implemented by using two air tanks. One tank is located in the front
and the other is located in the rear. This separation allows the front air tank
to operate the front brakes, the rear tank operates the rear drive axle brakes
and tag axle brakes if equipped with a tag axle. This tank division gives
reassurance in the event of one tank having a failure of an accessory air item
allowing the compressed air to escape. Accessory air items are other pneumatically
operated items such as the air horn, step well cover, vacuum generator, etc.
The accessory air items operate only when air tank pressures exceed 65 psi.
This is done with pressure protection valves. Should an accessory air item
fail, the pressure protection valve (PPV) will reserve remaining air pressure
of 65 psi for braking. This will leave the motorhome with one air tank fully
charged for a safety back up.
For a situation in which all compressed air has escaped from the rear air
tank, a pneumatic back-up safety valve is installed. This is the safety inver-
sion valve. The inversion valve senses the absence of rear air tank pres-
sure. In this case the inversion valve will allow the operator to make a mod-
ulated spring brake application, made in conjunction with the emergency
spring brake relay valve. The inversion valve allows the front air tank
pressure to recharge the rear brake chambers after the modulated spring
brake application has been made. This back-up system allows use of all the
brakes, allowing the operator to bring the vehicle to a safe stop. In the event
of all compressed air charge escaping from the front air tank, the operator
will still have full use of the rear brakes.
Chassis Information
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
D I P L O M A T 1 0 • 2 7 7
BRAKE SYSTEMS
- BACK-UP