Molpir COMPACT 1.6, Руководство по устранению неисправностей

Страница: 14 / 44

COMPACT 1.6
14
EN
Symptom Cause Solution
J
Equipment works but does not cool
down.
• Compressor do not work.
• Equipment is discharged.
• Blockage in circuits. • Proceed according to paragraph E.
• Vacuum in each circuit during 30 minutes and introduce 520 g of R134a.
• After verifying charge, check pressures and in case they are below 0.5 kg, while equipment is
working, clean circuits or replace obstructed component (possibly capillary tube).
K
The unit does not cool enough.
• The air distribution interior panel ducts are
not adjusted with the base of the device.
• Excess or lack of gas load.
• Communication cable disconnected or
defective.
• Continuous flow capillary pipe semi-
blocked (may be due to excess oil).
• Recirculation blocked or semi-blocked.
• Condenser/condenser fan grille dirty.
• Condenser fan defective.
• Condenser fan with polarity inverted.
• Adjust the air distribution interior panel ducts with the seal of the base of the device.
• Check pressure, at - temp. -; maximum reference pressure must be between 2.6 and 3 bars
in both circuits at an outside temperature of between 30º and 32º (always with one circuit with
slightly more pressure than the other).
• Connect or replace the communication cable.
• Take down and clean the obstructed component and replace if necessary. (1).
• Leave the recirculation input in the base of the device free.
• Clean condenser/grille.
• Replace the condenser fan.
• Check that the air is discharged to the outside, otherwise invert the connector connection.
L
Water filters inside cabin.
• EPDM joint badly assembled or deteriorated.
• Obstructed drainage pipes or without
drainage valve.
• Correctly place joint or replace it (it is very important to properly clean the surface where joint
will be assembled).
• Clean draining pipes and place the draining valve.
M
The unit does not respond to the user’s
selection orders.
• Electronic control or control panel faulty. • Replace electronic control or control plate.