Tool Kit for CSP 6.3 Receptacle Terminal
Doc No: ATS-6382558HM Release Date: 08-13-12
UNCONTROLLED COPY
Page 3 of 8
Revision: A
Revision Date: 08-13-12
ANVILS
POWER
CRIMP
HEAD
Figure 1
PUNCHES
M4 X 10 LONG
BHCS
M4 X 18 LONG
BHCS
SWING
LOCATOR
OPEN
PRESS DOWN
ON THE BRASS
PIVOT SHAFT
LIFT UP ON
THE LOCATOR
Figure 2
INSTALLATION
To install the Tool Kit into the Power Crimp Head follow the steps below:
Anvils and Punches Installation
1.
Insert the Anvils into the bottom slots of the nest. Install the M4 x 10 long BHCS and tighten in place.
2.
Insert the Punches into the top slots of the nest. Install the M4 x 18 long BHCS and tighten in place. See
Figure 1.
Locator Installation and Removal
Follow the steps below to install or replace the locator. See Figure 2.
To install the locator
1.
Position the locator with the hole over the brass pivot shaft and snap it into place.
To remove the locator
1.
Open the crimp hand tool.
2.
Swing the existing locator open and away from the
hand tool.
3.
Firmly press down on the brass pivot shaft with your
thumb, while pulling the locator up. Slip the locator
off the top of the brass pivot shaft.
OPERATION
Open the tool by squeezing the handles together, at the
end of the closing stroke, the ratchet mechanism will
release the handles, and the hand tool will spring open.
Crimping Terminals
1.
Select the desired terminal listed in the preceding charts.
2.
Turn the Locator Lock Latch down to unlock. See Figure 3.
Figure 3
LATCH LOCKED
LATCH UNLOCKED