Hand Crimp Tool For 3.18mm (.125”) Lighting Terminals
Doc No: ATS-638252600
Release Date: 03-21-12
UNCONTROLLED COPY
Page 4 of 7
Revision: A
Revision Date: 03-21-12
SQUEEZE
HERE
SQUEEZE
HERE
LOCATOR
Figure 7
TOP HOOKS
TOP SLOTS OF
HANDTOOL
LOWER TABS
Figure 9
PUSH ON
HANDLE
JAWS OPEN
PULL OPEN
TOOLING
TOOLING
M3 BHCS
Locator Replacement
See the parts list on the last page of this document for the
proper locator order number. Follow the steps below to
replace the locator.
1.
Open the crimp hand tool.
2.
Squeeze gently on the lower area shown in Figure 7 with
your thumb and index finger. The lower tabs of the
locator should disengage from the hand tool.
3.
Lift and pull away from the hand tool. The top locator
hooks should slip out of the top slots easily.
See Figure 7.
4.
To reinstall the new locator, make sure the hand tool is in the open
position.
5.
Holding onto the lower part of the locator with your thumb and index
finger, insert the locators top hooks (2) into the hand tool top slots.
6.
Rotate the locator down and press the lower tabs into the two bottom
slots of the hand tool. To secure the locator into place, the lower
tabs must snap into place on the hand tool frame.
Right or Left Hand Operation
This hand tool has an added feature that can be converted from a right
handed application to a left handed application. It is necessary to
reverse the tooling if using the left handed application along with the
locator. Follow the steps below:
1.
The locator must be removed before reversing the tooling.
TERMINAL
Figure 6
WIRE
STOP
WIRE
MATCH
UP MARKS
FRONT
BACK
Figure 9
