CRIMPING ARM
(UP POSITION)
LOCKING ARM
(UP POSITION)
REMOTE
SWITCH
EQUIPMENT CHECKLIST
HAND CRIMPER
(Shipped Separately)
PENDENT
ELECTRIC SEAMER
DO NOT PULL
DO NOT LIFT
When handling seamer tool, always use
the handles to lift or pull it.
NEVER PICK IT UP BY THE LOCKING
ARM OR PULL IT BY THE ELECTRIC
CORD
ERECTOR RESPONSIBILITY
This Seaming Equipment Kit was checked before shipment and found to be complete and in proper working condi-
tion. Upon receipt of this kit, inspect for any damage that may occurred during shipment. If any damage is discov-
ered, call MBCI immediately for instructions.
It is the erector’s responsibility to become familiar with, and operate, the seaming equipment in accordance with the
instructions provided in this manual using safe construction practices. Failure to adhere to these instructions could
result in damage to the seaming equipment and/or roof panels, or injury to erection personnel.
EM BattenLok
®
HS Seaming Information
The seamer and the hand crimper are shipped in individual specially designed boxes accompanied by a field man-
ual.
Read the field manual thoroughly before starting the seaming operation. Failure to adhere to these
instructions will result in damage to the seamer and/or panels. The erector will be held liable for any costs
incurred for replacement or repair.
Pre-Seaming Information
1. Locate field manual in the hand crimper or seamer box and review operational procedures.
2. Locate power source and check against power requirements in field manual.
3. Check seams for proper engagement.
4. Clean dirt, debris and excess sealant from seams and panel surfaces to avoid interfering with the
seaming operation.
5. Panels must be hand crimped at each clip and endlap as they are installed to prevent their separation
by a strong wind. Panels should be seamed with electric seaming tool as soon as possible after instal
lation.
EM BattenLok
®
HS
Field Seaming Tool Manual
