Distributor of Molex Connector Corporation: Excellent Integrated System Limited
Datasheet of 0622017500 - ARBOR PRESS - RAST 5.0
Contact us: [email protected] Website: www.integrated-circuit.com
RAST 5.0 Arbor Press
Doc: No: TM-622017500
Release Date: 12-20-00
UNCONTROLLED COPY
Page 8 of 19
Revision: E
Revision Date: 08-14-09
Figure 2-1
ADAPTER BLOCK AND SCREWS
TERMINATION HEIGHT
ADJUSTING KNOB
ADAPTER
BLOCK
ADAPTER BLOCK
LOCKING SCREWS
Figure 2-2
SETTING THE CONNECTOR GUIDE
2.1
Installation
Set the press on a bench of suitable height and
capable of supporting at least 70 kg (155 lbs). Using
the two (2) M4 X 12 FSHCs supplied with the press,
mount the Housing Load Platform to the press as
shown in Figure 1-1. (See also the assembly
drawing in Section 4.) There are two (2) clearance
holes in the base plate (see Fig, 1-1), for 8 mm or
5/16 in. screws, if it is desired to bolt the press to the
bench. Make sure there is adequate room around
the press for the operator to load connectors and to
store wires and finished harnesses. Make certain
there is adequate lighting.
2.2
Setup
2.2.1 Termination Height
Refer to Figure 1-1 and 2-1.
In order to insure the connector top half is correctly
seated in the lower half and that the wires are
correctly terminated, it may necessary to adjust the
termination height. This is done as follows:
1.
To adjust the termination height, loosen the
three (3) socket head cap screws that lock the
adaptor block to the press frame.
2.
To decrease the termination height (the height
of the connector after termination) turn the
height adjusting knob counterclockwise. To
increase the height, turn the knob clockwise.
3.
When the desired height is set, tighten the
locking screws. The height of the connector
after termination should be as follows:
a)
90833, 90888, 91338and 91954 series, height =
23 +0.2 / -0.1 mm.
b)
90835 and 91247 series, height = 25 +0.2 / -0.1
mm.
c)
See also sheet 4 of the application
specifications #AS-99033-0004.
2.2.2 Adjusting for Connector Size
The Rast 5 connectors come in various circuit sizes
from 1 to 12, and also in five types, two (2) of which
(90835 and 91247 Series) are 16A connectors and
are slightly taller and require the removal of a shim.
See Section 2.2.3 for details. Adjusting for circuit
size is as follows:
1.
Place a stack of connectors of the correct size
on the connector support and slide it forward
until it is between the adjustable guide block and
the fixed guide block.
2.
Push it up against the fixed guide block.
3.
Loosen the two (2) locking screws (See Figure
2-2).
4.
Slide the adjustable guide block toward the
connector until the connector stack can be slid
between the guides with no noticeable side play.
The connector holdown plates on both sides
should be in far enough that they hold the
9 / 20
9 / 20
