Molecular Devices QPix 420, Руководство пользователя

Страница: 200 / 225

QPix 420 Colony Picking System User Guide
200 5031496 G
5. Verify that the screws are all flush with the retaining plate.
6. Install the head on the actuator. See
Changing the Head on page 28 .
7. Test the fit in the actuator to be sure the fit is correct.
Any raised screw heads can foul the actuator when sliding the head into place, preventing
the head from being fitted. If you see an issue, either swap the positions of the screws or
replace the raised screw.
8. Run a Pin Fire Test. See Testing the Pins on page 200 .
Testing the Pins
The Pin Fire Test checks that the pins on an installed head are obstruction-free and can move
freely.
To test the pins:
1. From the Navigation window under Utility Processes, double-click the Instrument Utilities
icon.
2. In the Instrument Utilities window, double-click the Pin Fire Test icon.
3. When the Pin Fire Test message displays, make sure that the bed is clear of obstructions
and that the door is closed, and then click OK to move the actuator into position near the
front of the instrument.
If you have not previously installed the head to test, install it now. See
Changing the Head
on page 28 .
4. In the Pin Fire Test window, select the head to test from the Select Head list.
The window displays the number of rows and columns for the head.