7.
3D calibration
Press L /R to turn on the controller, the LED &LED will light on. Press SL to start the
Calibration. LED / / / will light on. Shaking the controller for several times and press SL to
finish the test.
8.
The instructions of USB
USB connector is for charging and update the system of the controller. When charging the controller
by USB, the controller can not connect the console through the slide way to avoid breaking the
console.
9.
Updating the system of the controller
If the console is updated, the controller also need to be updated. Please press the SL and
UP/DOWN/LEFT/RIGHT of left controller or A/B/X/Y of right controller, the controller will enter
into the PC mode. Connect the PC by USB(or press the SL and connect the PC by USB), updating the
controller through the system.
10.
Support the Wired function
Putting the controller on the Switch console through the slide way, the controller will connect the
console automatically, then the Bluetooth part of the controller will disconnect the Bluetooth of the
console. When the controller is out of power, the console will charge the controller when connecting
the console by wired.
The controller is for the Switch console. The console can support up to controllers pcs of left
controllers and pcs of right controllers or pcs of left controllers and pcs of right controllers to
connect the console at the same time.
三．
LED: Each controller have 4 LED, it can be used as channel or indicator.
a.
When the controller is off, press UP/DOWN/LEFT/RIGHT of left controller or A/B/X/Y of right
controller can turn on the controller. The 4 LED will light up circularly.
b.
Press the MODE button for 3 seconds, 4 LED will flash rapidly. After the controller is connected
with console successfully, the relevant LED will be light on.
c.
When the voltage of the controller is lower than 3.5V when connecting with the console, the
relevant LED will flash slowly. When the voltage of the controller is lower than 3.4V, the
