4.
Turn on/off or charging/ sleep mode of the controller
a.
Turn on/off of the controller
Turn on the controller by pressing UP/DOWN/LEFT/RIGHT of left controller or A/B/X/Y of
right controller. The 4 LED will flash slowly and circularly if the controller turn on. Pressing 3
seconds of the Mode button to enter the pairing mode, releasing the mode button after the 4 LED
flashing quickly and circularly. The LED will light on if the paring is successful.
Press the Mode button for 3 seconds, the controller will turn off when connect the console.
b. Charging mode of the controller
1)Charging the controller by USB when the controller is off, the 4 LED will flash slowly. The 4
led will turn off after the fully charge.
2)When the controllers connected with the console through the slide way, the controller will be
charged by the console if the console is charged by the USB.(If the console is not charged, when the
voltage of the controller is lower than 3.7V, the controller also will be charged by console.
c.
Sleep mode of the controller
1)Under the pairing, if the controllers can not connect with the console, the controller will turn
off automatically and enter into the sleep mode.
2)The controller will turn off automatically and enter into the sleep mode, if the controller have
not been operated within 5 mins when connecting the console.
5.
Re-set
Please reset the controller, if the controller is abnormal, like button disorder, crash, connecting
problem, etc. Please use the slender object, like needle, insert and press the reset hole on the back
of the controller, the controller will be reset.
6.
Sensor calibration
Put the controller on the table, Press SR+Mode to open the controller, the LED &LED will light
on. Then press the SL to calibration. Please note the controller must put on the table.
