5
Cooler Set-Up & Installation: Part 1 - Pre-Installation
©
MOJO Pure Water, LLC All Rights Reserved. 1-800-990-9775 mojowater.com
1. REMOVE EXTERNAL LID
Remove the lid on the Frost cooler
to expose the top of the Float Kit
(it is blue and covers the
reservoir). There is a small,
rounded “cut out” in the back of
the lid to help you remove it.
2. LIFT OUT FLOAT KIT
When you remove the External Lid
(previous step), you’ll see the
blue
Float Kit that seals the cold water
reservoir (and holds the 2 floats).
You need to remove that lid so
that you can check everything
inside the reservoir.
Just grab the two handles on the
sides and pull straight up (see
diagram on previous page).
3. CHECK FLOATS
Look under the Float Kit. You will
see 2 air-filled “floats” - a main
“float” (square) that shuts o
ff
the
water flow when reservoir is full,
and a round backup safety float if
the first float were to fail.
Occasionally, floats come loose in
transportation. If either float is not
attached, click it back into place.
Make sure that both floats can
freely move up and down.
FLOAT KIT
EXTERNAL LID
PRIMARY FLOAT
BACKUP FLOAT
4. CHECK BAFFLE
a)
Inside the stainless steel
reservoir, you’ll find a 2-piece
ba
ffl
e. Sometimes, this can come
loose in transportation. Push the
ba
ffl
e down to make sure that it is
secure. (If it is loose, it can rise up
and trip the floats.) If the ba
ffl
e is
dislodged, push it into the center
hole in the bottom of reservoir.
5. PRESS RESET BUTTON
a)
Push the Float Kit back into the
reservoir to seal it.
b)
Press red reset button. If the
round Backup Float (from Step 3)
is tripped, it shuts o
ff
all water to
the cooler as a safety precaution.
This can also happen in
transportation or if cooler gets
bumped (after it is installed).
In the future, if water does not
dispense, pushing the red button
usually fixes the issue.
6. REPLACE LID
Replace the external lid. You’re
now ready to proceed with set up.
BAFFLE
RESERVOIR
RESERVOIR
