Mojo Frost M1-22 Скачать руководство пользователя страница 2

2

IMPORTANT SAFEGUARDS

 

When using electrical appliances, basic safety precautions should always be followed, including:

1. Read all instructions before using. 

2. Do not let cord hang over edge of table or counter, or touch hot surfaces.

3. To protect against electric shock, do not immerse cord, plug, or cooler in water or any other liquid.

4. Close supervision is necessary when any appliance is used by or near children.

5. Unplug from outlet when not in use and before cleaning.

6. Do not operate any appliances with a damaged cord, plug or after the appliances malfunction, or has been 
damaged in any manner.

7. The use of accessory attachments is not recommended by the manufacturer and may cause injuries.

8. Do not use outdoors.

9. Allow at least 2” (5cm) of space between the back of the water cooler and the wall to allow for proper air 
circulation.

10. Install the water cooler on a level floor. Do not install where it will be subject to direct sunlight, heat or moisture.

11. Do not install water cooler where the temperature will go below 59°F (15°C) or above 100°F (38°C).

12. Do not plug in the power cord or turn on the hot water on/o

 switch when the water cooler is empty.

13. To disconnect the power cord, turn the hot water switch to “o

 “, then remove plug from wall outlet.

14. Always wash and dry your hands thoroughly before touching the water cooler.

15. Extreme caution must be used when moving an appliance that contains hot liquid.

16. Do not use this cooler to dispense anything other than water. (Yes, that means no beer….)

17. Do not use with water that is micro biologically unsafe or of unknown quality. 

SAVE THESE INSTRUCTIONS

 

18. This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric 
shock.

 

19. This appliance has a power cord with a grounding wire and a grounding plug. The plug must be plugged into a 
standard 3-prong outlet that is properly installed and grounded. The water cooler is intended to be plugged into a 
receptacle of the ground fault circuit interrupting type (GFCI) for water cooler installations in North America.

20. Consult a qualified electrician if the grounding instructions are not completely understood, or if doubt exists as 
to whether the appliance is properly grounded.

21. If the outlet is a standard 2-prong wall outlet, it is your personal responsibility and obligation to have it replaced 
with a properly grounded 3-prong wall outlet.

22. Do not under any circumstances cut or remove the third (ground) prong from the power cord.

23. Do not use an adapter plug with this appliance.

24. Do not use an extension cord with this appliance. If the power cord is too short, have a qualified electrician 
install an outlet near the appliance.

25. Never place your fingers or any sharp metal object inside the water cooler, as doing so may damage the cooler, 
and also increase the risk of electric shock.

26. Do not immerse the appliance in the water to clean.

27. The appliance should not be exposed to rain. 

28. If the power cord is damaged, it must be replaced by the manufacturer its service agent or similarly qualified 
persons in order to avoid a hazard.

PLEASE FOLLOW THE STEPS IN THIS MANUAL IN ORDER 

©

 

MOJO Pure Water, LLC   All Rights Reserved.  1-800-990-9775      mojowater.com  

Please visit mojowater.com/setup  

For MOJO SET-UP & TROUBLESHOOTING VIDEOS & 

updated installation manuals. Thank you.  

Содержание Frost M1-22









Отзывы: