MoJack XT, Инструкция по сборке и эксплуатации

Страница: 5 / 31

MoJack XT Lift MoJack XT Lift
8 9
Assembly Instructions
STEP 5
Nylock Nut 15
Carriage Bolt 13
Crank Handle 8
Tower 1
Attach the Crank Handle to the Tower by inserting
Carriage Bolt with threads facing up and fasten with
Nylock Nut .
Note: There are two holes in the Crank Handle. The hole
closest to the rubber grip will provide a 6” radius for
cranking. The other hole will provide an 8” radius, making
cranking easier. Use the hole that works best with your
model of lawn mower.
1 8
13
15
STEP 6
Hang the Lift Arm on the Carrier by hooking
the slotted area of the Lift Arm under the top
bar of the Carrier. Lift Arm must be inserted
from the front and then lowered which fastens
Lift Arm into place. Insert Clevis Pin through
the hole in the Carrier and lock by fastening the
Small Hair Pin to the Clevis Pin. 2
18
Lift Arm 2
Top Bar of Carrier
Carrier
Attach the Grip Handle to the Tower with
two Carriage Bolts and two Nylock Nuts .
STEP 4
Nylock Nut 15
Carriage Bolt 13
Tower 1
Grip Handle 7
7 1
13 15
Small
Hair Pin
18
Clevis
Pin 17
17
Lift Arm Insert 6
Push Pin 16
Push Pin 16
Lift Arm 2
Lift Arm Insert 6
Assembly Instructions
THIS COMPLETES ASSEMBLY.
Wheel Pad 5
STEP 8
Ready the Wheel Pads for installation by adding
Support Rods and Large Hair Pins .
5
11 19
Large Hair Pin 19
Support Rod 11
Push Pin 16
STEP 9
Slide the Wheel Pads onto both
sides of the Lift Arm Inserts and
secure with Push Pins .
Note: The Wheel Pads can be moved
in or out to fit different mower widths.
Use the configuration that works best
with your model of lawn mower.
5
6
16
Lift Arm Insert 6
Wheel Pad 5
Slide Lift Arm Inserts into both sides
of the Lift Arm and secure with
Push Pins as shown.
STEP 7
6
2
16