Mohawk USL-6000-K, Руководство пользователя

Страница: 14 / 39

MOHAWK MODEL USL-6000-K
1-7
MAINTENANCE PROCEDURES
QUALIFIED MAINTENANCE PERSONNEL ONLY
DAILY
•
PERFORM THE PRE-OPERATION CHECK LIST.
•
REPORT ANY AND ALL EQUIPMENT MALFUNCTIONS
IMMEDIATELY.
•
CLEAN ALL MOVING PARTS. IF OXIDIZATION IS OCCURRING
USE A LIGHT LUBRICANT. (WD - 40 OR EQUIVALENT )
•
KEEP AREA AROUND THIS EQUIPMENT FREE OF DIRT, SAND,
WATER, ETC.
WEEKLY
PERFORM THE DAILY OPERATION CHECK LIST.
WIPE CLEAN, THE CYLINDERS' WIPER SEALS. REMOVE ANY
WEEPING OIL AND DUST.
VERIFY FLUID LEVEL. WITH THE UNIT FULLY LOWERED, THE
FLUID LEVEL WILL BE 1/2 INCH BELOW THE BREATHER CAP
PORT. USE DEXRON III AS REPLACEMENT FLUID.
CYCLE UNIT TO FULL HEIGHT, NOTE ANY UNUSUAL NOISES,
INSPECT UNIT FOR WORN OR DEFORMED PARTS.
MONTHLY
INSPECT ALL HYDRAULIC COMPONENTS FOR LEAKS,
DEFORMATION, WEAR OR CORROSION.
TIGHTEN ALL FASTENERS AND HYDRAULIC FITTINGS AS
REQUIRED.
1. ALL O - RING BOSS FITTING JAM NUTS ARE TO BE
TIGHTENED TO 15 FOOT POUNDS TORQUE.
2.
ALL PIPE FITTINGS, IF LEAKING ARE TO BE REMOVED,
RE-SEALED, AND RE - INSTALLED. ( SELECT - UNITE
THREAD SEALANT OR EQUIVALENT ON FITTING
THREADS )
INSPECT ALL BUSHINGS FOR UNUSUAL OR EXCESSIVE WEAR.
SEMI- ANNUAL TRAINING
QUALIFY / RE-QUALIFY ALL PERSONNEL IN THE SAFE
OPERATION OF THIS UNIT.
ANNUALLY
REPLACE AND RE-BLEED THE HYDRAULIC FLUID. ALWAYS USE
A CLEAN FUNNEL AND FILTER. USE DEXRON III HYDRAULIC
FLUID.
INSPECT ALL BUSHINGS FOR UNUSUAL OR EXCESSIVE WEAR.
PERFORM THE DAILY, WEEKLY, AND MONTHLY MAINTENANCE
PROCEDURES.