Mohawk USL-600 Скачать руководство пользователя страница 3

Страница: 3 / 4

9. ONCE PIN IS PUSHED ASIDE, PRY END OF ROD OUT UNTIL PIN CLEARS SIDE PLATE.

WARNING: ROD END WILL TRY TO FLIP UP. KEEP FIRM GRIP ON ROD END
DURING THIS STEP. SEE PICTURE BELOW.

10. ONCE ROD IS FREE OF MAIN TUBE, PIVOT CYLINDER SO ROD IS POINTING UP. SEE
BELOW.

Содержание USL-600

Страница 1: ...ENT PROCEDURE FILE USL CYL DOC REVISION 6 30 98 TOOLS NEEDED CROW BAR C CLAMP ALLEN WRENCH 11 16 WRENCH OR CRESENT WRENCH MALLET PAPER TOWELS OR RAGS 6 JIC CAP NUTS 1 RAISE LIFT MID TO FULL HEIGHT ABOVE 6TH OR 7TH LOCK POSITION ...

Страница 2: ...S AS SHOWN ENSURE THAT CLAMP IS SNUG 4 DISCONNECT HYDRAULIC LINE AT BOTTOM OF CYLINDER ROD 5 CAP VELOCITY FUSE AT END OF CYLINDER ROD LOOSELY 6 REMOVE SET SCREW AT END OF CYLINDER ROD 7 PLACE RAGS OR PAPER TOWELD UNDER ROD END ON FLOOR 8 USE CROW BAR TO PRY PIN OUT OF END OF SUPPORT PLATE AT CYLINDER ROD END A SOCKET MAY BE HELPFUL TO SHIM THE PIN OUT OF THE HOLE ...

Страница 3: ...DE PRY END OF ROD OUT UNTIL PIN CLEARS SIDE PLATE WARNING ROD END WILL TRY TO FLIP UP KEEP FIRM GRIP ON ROD END DURING THIS STEP SEE PICTURE BELOW 10 ONCE ROD IS FREE OF MAIN TUBE PIVOT CYLINDER SO ROD IS POINTING UP SEE BELOW ...

Страница 4: ...LOW 12 INSTALL NEW CYLINDER BY REVERSING STEPS NOTE NEW CLYINDER WILL HAVE RETRACTED ROD WAIT UNTIL CYLINDER IS PLACED BETWEEN SIDE SUPPORT ARMS THEN PIVOT CYLINDER LOOSED FITTING ON END OF ROD PULL OUT ROD TO SECURE ROD END PIN TO MAIN TUBE AT BOTTOM OF LIFT ALWAYS BLEED SYSTEM AFTER REPLACING REPAIRING CYLINDER END OF DOCUMENT ...