Mohawk RJ-15, Установка, Эксплуатация, Обслуживание, Запчасти

Страница: 11 / 32

MOHAWK MODEL RJ-15 & RJ-25
5
INSTALLATION INSTRUCTIONS
IMPORTANT
READ THIS MANUAL IN ITS ENTIRETY. BE FAMILIAR WITH PART NAMES AND HAVE A GOOD UNDERSTANDING
OF HOW THIS UNIT IS TO BE ASSEMBLED AND OF HOW INDIVIDUAL
PARTS OPERATE, BEFORE ASSEMBLING THE UNIT.
REFER TO ANSI/ALI ALIS, SAFETY REQUIREMENTS FOR INSTALLATION AND SERVICE OF AUTOMOTIVE LIFTS.
SET THE OFF SIDE TRACK ON THE LIFT UNIT OUT AWAY FROM
THE MAIN SIDE TRACK. THE INSIDE DIMENSION BETWEEN THE
MAIN AND OFF SIDE TRACK IS TO BE TWO INCHES WIDER THAN
THE OUTSIDE DIMENSION OF THE JACKING BEAM.
PLACE THE JACKING BEAM BETWEEN THE TRACKS. SUPPORT
THE UNIT OFF OF THE TRACKS WITH TWO PIECES OF 4 X 4 X 12
INCH DUNNAGE.
REPLACE THE OFF SIDE TRACK BACK TO IT'S ORIGINAL
POSITION OF 48” FROM THE MAINSIDE TRACK.
NOTE
THE MEASUREMENT BETWEEN THE TRACKS AT THE FORE AND
AFT END OF THE UNIT MUST BE THE SAME.
RAISE THE LIFT UNIT INSURING THAT THE WHEELS ON THE
JACKING BEAM ARE MAKING PROPER CONTACT WITH TRACK
RAILS
FINE ADJUSTMENTS TO THE WHEELS CAN BE MADE BY
LOOSENING THE PIN SET SCREW AND ADJUSTING WHEEL
POSITION. WHEN THE ADJUSTMENT IS COMPLETE TIGHTEN THE
SET SCREWS.