2
Operating Instructions
Safety Instructions
Consumer Support
Troubleshooting T
ips
■
Install or store where it will not be exposed to
temperatures below freezing or exposed to the
weather, which could cause permanent damage
and invalidate the warranty.
■
NOTE:
This appliance must be properly
grounded, and electrical service to the washer
must conform with local codes and ordinances
and the latest edition of the National Electrical
Code, ANSI/NFPA 70.
IMPORTANT SAFETY INFORMATION.
READ ALL INSTRUCTIONS BEFORE USING.
WARNING!
For your safety, the information in this manual must be followed to minimize the risk
of fire or explosion, electric shock, or to prevent property damage, personal injury,
or loss of life.
WATER HEATER SAFETY
Under certain conditions, hydrogen gas may be produced in a water heater that has not been used
for two weeks or more. Hydrogen gas can be explosive under these circumstances.
If the hot water has not been used for two weeks or more, prevent the possibility of damage or injury by
turning on all hot water faucets and allowing them to run for several minutes. Do this before using any
electrical appliance which is connected to the hot water system. This simple procedure will allow any
built-up hydrogen gas to escape. Since the gas is flammable, do not smoke or use an open flame or
appliance during this process.
PROPER INSTALLATION
This washer must be properly installed and located in accordance with the Installation Instructions
before it is used. If you did not receive an Installation Instructions sheet, you can receive one by
visiting
GEAppliances.ca
, or by calling
1.800.361.3400
.
Installation Instructions
The instructions in this manual and all other literature included with this washer are not meant to cover
every possible condition and situation that may occur. Good, safe practices and caution MUST be applied
when installing, operating, and maintaining any appliance.
ELECTRICAL REQUIREMENTS
CIRCUIT -
Individual, properly polarized and grounded circuit, protected by a 15 Amperes circuit breaker or fuse.
POWER SUPPLY -
2-wire, with ground, 120 Volt, single phase, 60 Hz alternating current.
OUTLET RECEPTACLE -
Properly grounded 3-prong receptacle to be located so the power supply cord is accessible when
the washer is in an installed position.
GROUNDING REQUIREMENTS
This appliance must be grounded. In the event of malfunction or breakdown,
grounding will reduce the risk of electric shock. This appliance is equipped with a cord
having an equipment-grounding conductor and a grounding plug. The plug must be
plugged into an appropriate outlet that is properly installed and grounded in
accordance with local codes and ordinances.
DO NOT -
modify the plug provided with the appliance.
DO NOT -
cut off or alter the grounding prong on the power cord. If the plug will not
fit the outlet, have a proper outlet installed by a qualified electrician.
DO NOT -
use an extension cord or adapter plug.
WARNING!
Improper connection of the equipment grounding conductor can result in a risk of
electrical shock. Check with a licensed electrician if you are in doubt as to whether the
appliance is properly grounded.
