Moeller XControl XC600, Оборудование, инженерия и описание функций, Страница: 31 / 78

07/04 AWB2700-1428GB
27
3 Creating an Example Project
The following example is used to illustrate the use of the XSoft
software. A project is created by creating a configuration and a
program. After the project is downloaded, the program can be
tested.
A configuration is made with the XSoft configuration editor. This
enables input/output modules such as XI/ON modules and
CANopen and PROFIBUS-DP modules to be configured locally and
remotely. The hardware configuration shown in Figure40 is the
basis of the configuration.
In the first part of this example you will configure the XC600 PLC.
It is configured with two digital input modules and two output
modules (relays). A program is shown that links the inputs
together in an AND combination and sends the result to an output.
In the second part, you will add a remote I/O combination (2 input
modules and 2 output modules) to the XC600. This is connected
to the master via the PROFIBUS-DP network. An additional
program will combine two inputs and send the result to an output.
In the third part, a remote WINbloc output module is added to the
XC600. This is connected to the master via the CANopen bus
network. An additional program is used to send two values to the
outputs.
Figure 40 : Configuration of the example project
PROFIBUS-DP
CANopen-BUS
Bridge
= > ? @ = > ? @ A B
Modules:
=
2 digital inputs
>
2 digital inputs
?
2 digital outputs
@
2 digital outputs
Modules:
=
Gateway
>
Power supply module
?
2 digital inputs
@
2 digital inputs
A
2 digital outputs
B
2 digital outputs
Bridge
WINblock
output module
The XC600 consists of:
XC-SYS1 Operator module
XC-CPU601-E4M CPU
XC-NET-CAN CANopen module
XC-NET-DP-M PROFIBUS-DP module
XC-POW50-XION-UPS Power supply module
XC-ADP-XION Base module