6
Power Up:
You are ready to power the unit up if the following has been done:
1)
Tubes are installed in the ELYSE DAC and cover secured in place.
2)
AC power has been plugged into IEC power inlet, of appropriate AC mains voltage as
indicated on back of ELYSE DAC.
3)
Digital input cables are connected.
4)
RCA or XLR signal cables are connected from main outs of ELYSE DAC to preamp.
5)
Be sure that only RCA OR XLR analog cables are connected, not both at the same time.
Depress the power button on front face of unit, to power up the ELYSE DAC. When first
powered on, a blue LED above the power switch will blink and blue led above mute switch will
be lit. The unit will remain in mute for approximately 15-seconds, allowing for tubes to stabilize
and gently reach operating voltage. When unit is operational, mute LED may remain lit, until a
digital input with valid signal is selected. On invalid signal from selected digital input, unit will
automatically mute the analog outputs.
Содержание ELYSE Tube DAC
Страница 12: ...12 ...