MODULARWALLS Slimwall Classic Post, Руководство по установке

Страница: 19 / 36

Seal here
An Expressed Joint is used to create an architectural feature by providing a 10mm rebate between horizontal
panels.
See example below of an 1800mm high SlimWall with Expressed Joints. This 1800mm high SlimWall is made
up of 3 x 600mm panels.
1. SETTING YOUR BRACKET HEIGHT
For every Expressed Panel Joint you need to add 15mm on top of your normal bracket height as outlined in
Step 3.
EXAMPLE: You are installing an 1800mm high wall as per the guide given in step 3. This measurement from
the top of post to the bracket is 1805mm. If you are installing an expressed joint this will increase by 15mm (per
joint) to 1820mm. If you you had two expressed joints on an 1800mm wall as per the picture below you will
need to add 30mm.
2. INSTALLING THE EXPRESSED JOINT JOINING PROFILE
Install the Expressed Joining Profile in between the horizontal panel joins by simply pushing it into place between
the external skins of the lower panel. Guide the top panel down over the profile in a similar manner as outlined in
Step 7.
3. SEALING
To prevent water ingress, seal between the inside of the rebate and the post junction with an exterior grade
‘paintable’ sealant upon completion.
ADDITIONAL
EXPRESSED JOINTS BETWEEN PANELS
SLIMWALL™ INSTALLATION GUIDE 19