MODSTER 282310, Руководство пользователя

Страница: 23 / 38

User Manual MODSTER Digger
23 www.modster.at
Transmitter
Follow the switch-on sequence:
- Throttle / brake lever in neutral position
- Steering lever in neutral position
- First switch on the transmitter and then switch on the model
Otherwise the model may react unpredictably!
• Put the model in a starting position, where chains and power unit can rotate freely.
• Check the range of your remote control system before starting the model.
• Check the reaction of the servos to the remote control signals on the standing model.
• Make sure that the batteries of the transmitter and receiver are fully loaded.
• Weak batteries reduce the transmitter range and lead to errors in the signal transmission to the
receiver. As a result, the model no longer reacts correctly to the remote control.
• Stop operating immediately and then replace the batteries with new ones or recharge them.
• Do not drive near high-voltage lines or radio masts or during a thunderstorm. Electrical fields and
atmospheric disturbances can affect the signals of your remote control transmitter.
• After the operation switch off the model first, then the transmitter.
• For safety and approval reasons (CE), unauthorized repair attempts and the conversion and / or
modification of the system are not permitted. Otherwise the approval of the remote control system
expires.
Driving
Do not drive, if your ability to react is limited (e.g. fatigue, medication or alcohol). Incorrect reactions
can cause serious personal injury and property damage. Do not drive too, if you have the slightest
doubt about the flawless, technical condition of your model / your remote control system. If it is
an electric model, connect the power unit AFTER the full installation of the transmitter, because
otherwise the power unit could start to run accidentally. Always keep your model in direct sight.
Only operate the model on private premises or in designated areas. Observe the requirements and
regulations for the terrain. When operating a model, always make sure that there are never any body
parts or objects in the danger area of engines or rotating parts. Regularly check all screw connections
and fastenings, as these can loosen or loosen during the operation.
Immediately stop operating your model in the event of a malfunction and rectify the cause of the
malfunction before continuing to use the model. Avoid driving in low outside temperatures, as this
will reduce the battery capacity and the plastic of the body will lose elasticity and splinter easily.
Your model and the remote control system should not be exposed to direct sunlight, moisture, heavy
pollution or excessive heat / cold for long periods. Only use original spare parts.
Do not drive...
- near or towards crowds of people or animals
- in nature reserves or at night or in living rooms, under high-voltage lines, radio masts or during
thunderstorms
- electrical fields and atmospheric disturbances can influence the signals of your remote control
transmitter
- please note, that RC models must not be driven on areas with public passenger and motor traffic, in
the rain or in damp areas, as otherwise the electrical system could be damaged.